QUEST

Detecting Academy

Learn how a metal detector finds a target with an interactive sideways sweep. Explore more detecting concepts below.

How a detector finds metal

Sweep the coil from side to side. Watch a buried coin respond, then read the example target ID at the control box.

A QUEST detector sweeping sideways above a flat, partly buried coin.Target ID85
Transmitted magnetic fieldDD sensitivity contoursEddy currents inside the coinSecondary magnetic field
Enlarged flat coin: currents circulate inside the metal; secondary magnetic field lines pass through the coin and close outside it.

Inside and around the coin

Arrows show one instantaneous current and field direction, related by the right-hand rule. Both reverse during the AC cycle; the response can lag the transmitted field. The close-up stays visible for reference.

The solid amber curves show the transmitted magnetic field of a representative D-shaped winding. The second D winding receives the response. Faint dotted contours show relative sensitivity beneath their overlap; they are not field lines or a detection boundary.

LeftRight
ShallowDeep
Blue response

The ID appears when the coil passes over the coin.

Principle illustration using representative D windings and a circular eddy-current model, not a calibrated simulation of this product. Curves show one instant of the AC cycle. Sensitivity depends on target orientation, depth and the actual windings. IDs 80–85 are teaching examples. The covered half of the flat coin is shown at 50% opacity.

01

Recovery speed

Sweep across a nail and a nearby coin. Can you hear two responses?

Ground sectionSoil
–
ResponseSweep position →
━ Response

Recovery speed

Advanced settings

The nail’s longer tail runs into the coin response. On clean ground a slower setting can favour weak, isolated targets.

Normalized model · synthesized audio. Slow motion is silent.
02

Discrimination

Reject a response band, sweep, then uncover the objects.

Ground sectionSoil
–
ResponseSweep position →
━ Response

Discrimination

Target ID bands · tap to reject or accept

Both targets in the middle band sound alike. ID alone cannot tell a pull tab from a small gold ring.

Normalized model · synthesized audio. Slow motion is silent.
03

Noise cancel

The metal detector listens for echoes on the frequencies it transmits. If a nearby detector uses one of them, you may hear chatter. Try moving the listening window.

① Where does the interference land?

Taller peaks mean stronger interference. In this example, 13 channels run from lower to higher frequency. The window shows which frequencies the detector is listening to.

12345678910111213
▲ Interference▯ Listening window

② Score each channel. Find the shortest bar.

Hold the coil still, away from metal, and start the scan. Each finished channel gets a score. Lower is quieter.

12345678910111213Simulated scores and audio.

Nearby detector

Channel 8 · Ready

The listening window overlaps the peak. Turn on sound and listen to the current channel.

04

Multi-frequency

Sweep the same ring and coin at one frequency, then at simultaneous frequencies.

Ground sectionSoil
–
ResponseSweep position →
━ Single frequency

Multi-frequency

One frequency gives one response profile across both objects. Keep it as a reference.

Normalized model · synthesized audio. Slow motion is silent.
05

Threshold

Adjust the background hum and listen to the same weak target. At which level is the change easiest to hear?

Ground sectionSoil
–
ResponseSweep position →
━ Response┄ Background hum╌ Interference

Threshold

With the hum off the weak target still produces a response here. Listen again with a faint hum.

Normalized model · synthesized audio. Slow motion is silent.